39
Changing Needles
z
Raise the needle by pressing the up/down needle
button and lower the presser foot.
Turn off the power switch.
Loosen the needle clamp screw by turning it
counterclockwise.
x
Remove the needle from the clamp.
Insert the new needle into the needle clamp with
the flat side to the rear.
When inserting the needle into the clamp, push it
up as far as it will go and tighten the clamp screw
firmly.
c
To find a good needle, put the flat side of the
needle onto something flat (a needle plate, glass,
etc.).
The gap between the needle and the flat surface
should be consistent. Never use a bent or blunt
needle.
q
Needle clamp screw
w
Pin
e
Needle clamp
To Attach and Remove Presser Feet
Press the red button on the back of the foot holder.
The presser foot will drop off.
Place the selected presser foot so the pin on the foot
lies just under the groove of the foot holder. Lower
the presser bar to lock the foot in place.
q
Red button
w
Groove
e
Pin
q
w
e
e
w
q
z
x
c
Summary of Contents for Harmony 8100
Page 1: ......
Page 63: ...834 853 005 E Printed in Japan...
