26
Threading the Machine
•
Threading the machine
* Raise the thread take-up lever to its highest position by
pressing the needle position up/down button
q
.
* Raise the presser foot lifter.
* Place a spool on the spool pin, with the thread coming
off the back of spool (refer to page 24).
NOTE:
The needle threader can be used with a #11 to #16
needle, or a #11 Blue needle.
Thread size 50 to 90 is recommended.
Needle Threader
CAUTION:
Turn OFF the power switch when using the needle
threader.
q
Knob
w
Hook
e
Guide
r
Thread end
z
Raise the needle to its highest position. Pull down the
needle threader knob
q
as far as it will go.
x
Turn the knob
q
in the direction of the arrow, then insert
the hook
w
through the needle eye.
Paying close attention to the needle point, draw the
thread around the guide
e
and under the hook
w
.
c
Release the knob slowly while holding the thread end
r
with your hand. A loop of the thread is pulled up through
the needle eye.
z
Draw the end of the thread around the upper thread
guide
w
.
x
While holding the thread near the spool, draw the end of
the thread down around the check spring holder
e
.
c
Firmly draw the thread up from right to left over the
take-up lever
r
, and down into the take-up lever eye.
v
Pass the thread through the lower thread guide
t
.
Slide the thread behind the needle bar thread guide on
the left.
b
Thread the needle from front to back, or use a needle
threader.
q
Needle position up/down button
w
Upper thread guide
e
Check spring holder
r
Thread take-up lever
t
Lower thread guide
5
4
3
1
2
z
c
v
b
x
z
x
c
q
w
e
r
q
e
r
t
w
Summary of Contents for Hello Kitty 18750
Page 1: ...Instruction Manual Manual De Instrucciones Livre D Instructions...
Page 98: ......
Page 99: ......
