29
REPLACING DC MOTOR AND ADJUSTING
MOTOR BELT TENSION
Pressure 300g
Belt tension:
7~9 mm
Setscrews (2)
DC motor
Belt
TO REMOVE:
1. Remove the front and rear covers (see page 7 and 8).
2. Remove the two setscrews, then remove the DC motor and belt.
TO INSTALL:
3. Lightly tighten the two screws.
4. Put the motor belt on the pulley and adjust the belt deflection to about 7 to 9 mm by pressing the middel of the
motor belt with your finger (with approximately 300 grams of pressure). Then, tighten the screws firmly.
5. Install the front and rear covers.