41
v
Open the fabric after sewing is finished.
Blind Hemming
q
Stitch pattern:
11 or 12
w
Thread tension dial: 1 to 4 (for stitch pattern 11)
3 to 6 (for stitch pattern 12)
e
Presser foot:
Blind hem foot G
z
Fold a hem with the wrong side of the fabric up to
form a 0.5 cm (1/4˝) allowance.
q
Wrong side of fabric
w
0.5 cm (1/4˝)
(1) On heavyweight fabrics that tend to ravel, the raw
edge should be overcast first.
(2) Fold the hem under the fabric for lightweight
fabrics.
x
Place the fabric so that the fold is next to the guide on
the foot.
Lower the presser foot.
Adjust the needle drop position if necessary.
c
Sew while guiding the folded edge.
e
Folded edge
r
Guide
Adjusting the needle drop position
Adjust the needle drop position as follows:
Press the “–” sign on the stitch width adjusting key
q
to
move the needle to the right.
Press the “+” sign on the stitch width adjusting key
q
to
move the needle to the left.
q
Stitch width adjusting key
The LCD display shows a distance from the center
needle drop position in millimeters.
The needle drop position can be varied from 0.0 to 1.2.
z
x c
v
q
w
e
r
q
w
(1)
(2)
4
w
e
q
q
NOTE:
If the needle pierces too far left, the stitch will show
through on the right side of the fabric.
NOTE:
The needle drop position can be moved, but the stitch
width will remain the same.
Summary of Contents for M50QDC
