35
Sensor (Square) buttonhole
Select pattern B1.
To sew
1 Attach the automatic buttonhole foot R snapping the
pin into the groove of the foot holder. Raise the
presser foot.
2 Pull the button holder to the rear, and place the
button in it. Push it tightly against the button.
NOTES:
The buttonhole size is automatically set by placing a
button into the button holder in the rear of the automatic
buttonhole foot R.
The button holder of the foot takes a button size of up to
2.5 cm (1") in diameter.
If the button is extremely thick, make a test buttonhole
on an extra piece of the fabric. If it is difficult to fit the
button through the test buttonhole, you can lengthen the
buttonhole by pulling the button holder back a little. The
length of the buttonhole will be increased.
3 Pull the buttonhole lever down as far as it will go.
4 Press the start/stop button to sew the buttonhole.
NOTE:
A warning message will appear and the machine will
stop automatically if you start to sew a buttonhole
without pulling down the buttonhole lever.
Press the exit key and pull down the buttonhole lever to
restart.
5 When buttonhole sewing is finished, push the
buttonhole lever up as far as it will go.
6 Remove the fabric and place a pin just below the
bartack at each end to prevent accidentally cutting
threads. Cut the opening with the seam ripper. Use
an eyelet puncher to open a keyhole buttonhole.
4
Buttonholes(B)
6
2
3
5
7
8
9
10
11
12
13
14
15
16
R
17
18
19
20
21
1
Sensor BH
Pull down BH Lever.
AUTO
NOTE:
Make sure there is no gap between the slider and front
stopper, otherwise the left and right lengths will be
different.
X
Pull down BH Lever.
Step-1
Step-2
Step-3
1
2
3
4
5
6
No gap
