18
Hexagonal socket screw (4 x 6)
Setscrew (B)
Threaded hole
Zigzag foot A
0.8 – 0.9 mm
The surface of
needle plate
Feed dog teeth
Adjusting screw
Setscrew (A)
Nut
Presser foot lifter button
Start/Stop button
Reverse
stitch button
⇒
Mechanical adjustment
Feed dog height
The highest position of the feed dog should be between 0.80 and 0.90 mm from the surface of the needle plate.
1. Attach the zigzag foot A. Remove the bed cover
(see page 3).
2. Turn the power switch ON while pressing the Start/Stop
button and the Reverse stitch button to enter the factory
setting mode.
Press "Feed Dog" key. The presser foot pressure value will
be set at "Auto +4", and the stitch length value will be set
at "5.0" automatically.
3. Press the presser foot lifter button to lower the presser
foot.
4. Turn the handwheel toward you to raise the feed dog at its
highest position.
5. Loosen the setscrew (A).
6. Loosen the nut. Turn the adjusting screw to adjust the feed
dog hight.
The highest position of the feed dog should be between
0.80 and 0.90 from the surface of the needle plate.
7. Tighten the nut and setscrew (A).
8. Be sure that the feed dog teeth are pararell with the
surface of the needle plate. If not, follow the adjustment
procedure below.
Feed dog parallel adjustment
1. Prepare the hexagonal socket screw (4x6).
Insert the hexagonal socket screw to the thraded hole, and
turn it until the tip of the screw reaches to the bottom.
2. Loosen the setscrew (B).
3. Turn the hexagonal socket screw and adjust the feed dog
parallel to the needle plate.
4. Tighten the setscrew (D).
5. Remove the hexagonal socket screw.
6. Be sure the feed dog and needle plate are pararell.
