q
w
e
r
t
e
Replacing DC Motor and Motor Belt Tension Adjustment
Replacing DC motor:
To remove:
1. Remove the belt cover.
2. Remove the screw A
q
and the moter belt.
3. Pull out the motor connector
w
from the
printed circuit board A.
4. Remove screws B (2 pieces)
e
and replace
the motor.
To attach:
5. Follow the above procedure in reverse.
Adjusting motor belt tension
To adjust:
1. Tighten screws B (2 pieces)
e
temporarily.
2. Adjust the belt deflection to about 5.0 mm
r
by pressing the middle of the motor belt with
your finger with approximately 200 grams
t
of pressure.
3. Tighten the screws firmly
e
.
q
Screw A
w
Motor Connector
e
Screws B (2 pieces)
r
Deflection 5 mm
t
Pressure 200 grams
31
Summary of Contents for Memory Craft 10001
Page 1: ...SERVICING MANUAL...
Page 42: ...40...
