q
t
w
y
u
i
e
r
Adjusting X and Y Sensor (Instant Adjustment)
To adjust X and Y sensor (without removing
the base unit):
1.
Remove the base cover.
2.
Remove the presser foot holder and attach
the embroidery hoop A.
3.
Place the template
q
on the hoop.
4.
Turn the Power ON and select the
Embroidery Mode, then press pattern No.1.
5.
Turn the handwheel by hand to check that
the needle drops into the starting position
w
(rounded hole) on the template.
6.
Turn the Power OFF.
7.
If the needle position shifts in Y direction,
loosen screw A
e
and move the Y sensor
fixing plate
r
to adjust the needle drop
position
t
.
8.
If the needle position shifts in X direction,
loosen screw B
y
through the sheet cover
fixing plate hole and adjust the X shield plate
position
u
.
9.
Turn the Power ON and select pattern No.1
on the Embroidery Mode, then check the
start position
w
.
10. Return the carriage to the home position and
turn the Power OFF.
11. Remove the template
q
and the embroidery
hoop, then reattach the base cover.
q
Template
w
Start Position
e
Screw A
r
Y Sensor Fixing Plate
t
Needle
y
Screw B
u
X Shield Plate
i
Sheet Cover Fixing Plate Hole
38
Summary of Contents for Memory Craft 10001
Page 1: ...SERVICING MANUAL...
Page 42: ...40...