e
e
q
w
r
t
y
u
i
o
Replacing the base unit
To remove:
1. Remove the Screws A
q
and B
w
, then
remove the Screws C
e
(4 pieces).
Detach the Base Unit.
2. Disconnect the X Motor Connector
r
then
Y-Motor Connector
t
from board A.
q
Screw A
w
Screw B
e
Four Screws C
r
X Motor Connector (Blue)
t
Y Motor Connector (White)
To attach:
3. Attach the X
r
, Y
t
Motor Connectors to
board A.
4. Insert the X, Y-Motor Cords
y
between the
board A and arm without touching the Feed
Motor, then tighten screws (4 pieces)
temporarily.
5. Attach the Extension (Accessory) Table
u
.
6. Align the Extension Table
u
, Base Unit, Free
Arm and tighten the Screw A
o
.
7. Tighten Screws while aligning the Extension
Table.
y
Insert the Cord in this place
u
Extension Table
i
Screws
o
Screw A
Note:
After attaching the Base Unit, check the
“Checking the Knee Lifter Link Play (1)”
and “Adjusting Presser Foot Sensor”.
(see page 28)
Changing External Parts (5) Base Unit
5
Summary of Contents for Memory Craft 10001
Page 1: ...SERVICING MANUAL...
Page 42: ...40...