Janome Memory Craft 5000, Servicing Manual

1

TABLE OF CONTENTS

TO CHANGE THE FACE PLATE UNIT AND TOP COVER UNIT .............................................. 2

TO CHANGE THE BELT COVER UNIT ..................................................................................... 3

TO CHANGE THE BED COVER UNIT ...................................................................................... 4

TO CHANGE THE BASE COVER ............................................................................................. 5

TO CHANGE THE BASE UNIT .................................................................................................. 6

TO ADJUST THE PRESSER BAR HEIGHT AND DIRECTION ................................................. 7

TO ADJUST THE NEEDLE POSITION ..................................................................................... 8

TO ADJUST THE NEEDLE BAR HEIGHT ................................................................................. 9
TO ADJUST THE HOOK TIMING ................................ ............................................................ 10

TO ADJUST THE CLEARANCE BETWEEN NEEDLE AND HOOK ............... ....................... 11

TO ADJUST THE BACKLASH OF HOOK DRIVE GEAR AND LOWER SHAFT GEAR ......... 12

TO ADJUST THE UPPER SHAFT SHIELD PLATE POSITION ............................................... 13

TO ADJUST THE NEEDLE THREAD TENSION ..................................................................... 14

TO ADJUST THE FEED DOG HEIGHT ................................................................................... 15

TO CHANGE THE THREADER PLATE AND ADJUSTMENT.................................................. 16

TO ADJUST THE STRETCH STITCH FEED BALANCE ........................................................ 17

TO CHANGE THE FRONT PANEL UNIT ................................................................................. 18

TO CHANGE THE “A” BOARD UNIT ....................................................................................... 19

TOADJUSTTHETOUCH PANEL .............................................................................................. 20

DRAWING FOR “A” BOARD CONNECTORS (FRONT PANEL COMPLETE UNIT) .............. 21

TO CHANGE BOARD C AND FUSE ....................................................................................... 22

TO CHANGE DC MOTOR AND BELT TENSION ADJUSTMENT ........................................... 23

TO CHANGE THE TRANSFORMER ....................................................................................... 24

TO CHANGE THE RECEPTACLE (MACHINE SOCKET UNIT) .............................................. 25

TO CHANGE THE LCD UNIT .................................................................................................. 26

TO CHANGE THE “F” BOARD UNIT ....................................................................................... 27

TO ADJUST THE BUTTONHOLE LEVER ............................................................................... 28

TO CHANGE THE BH LEVER (UNIT) ...................................................................................... 29

TO ADJUST THE SOLENOID ................................................................................................. 30

TO CHANGE MULTI LANGUAGE SELECTION MODE ........................................................... 31

MEMORY CRAFT 5000 DIAGNOSIS CHART .......................................................................... 32