AAASewing.com
80
5
3
4
1
5
4
3
2
1
2
1
2
1
2
SECTION VII. BUTTONHOLE
1
2
• Preparation for sewing
Groove
Pin
Attach the automatic buttonhole foot R. Make sure the
groove on the foot holder catches the pin on the foot when
lowering the presser foot.
• To sew
Button holder
Buttonhole lever
The buttonhole size is automatically set by placing the
button in the rear of the automatic buttonhole foot.
The button holder on the foot takes a button up to 1.0"
(2.5 cm) in diameter.
Make a test buttonhole on an extra piece of the fabric to
check your settings.
Use interfacing on stretch fabrics.
Pull the button holder to the back, and place the
button in it. Push it forward tightly against the button.
Pull the buttonhole lever down as far as it will go.
1
2
2
1
1
2
1
5
4
3
2
Automatic Buttonhole
Stitch selector:
(BH)
Stitch width:
3 to 6.5
Stitch length:
0.25 to 1.0
Needle thread tension:
2 to 6
Presser foot R:
Automatic buttonhole foot
Janome MS5027 Instruction Manual
Janome Pink Ribbon
www.aaasewing.com
MS5027 Owners Manual/ User Guide
