22
MECHANICAL ADJUSTMENT
ADJUSTING BUTTONHOLE LEvER POSITION
TO ADJUST THE BUTTONHOLE LEvER GUIDE:
1. ENTER THE BUTTONHOLE SENSOR ADJUSTING MODE. (SEE BELOW. THE LCD SHOULD
DISPLAY BH SYMBOL.)
2. REMOVE THE FACE COVER (SEE PAGE 8) AND LOOSEN THE SETSCREW (A).
3. MOVE THE BUTTONHOLE LEVER GUIDE SO THE BH SYMBOL DISAPPEAR WHEN THE
BUTTON HOLE LEVER IS LOWERED. TIGHTEN THE SETSCREW (A). TO ADJUST THE
BUTTONHOLE SENSOR POSITION.
4. ATTACH THE BUTTONHOLE FOOT (R).
5. LOWER THE BUTTONHOLE LEVER TO ITS LOWEST POSITION AND OPEN A 1.6 MM GAP
BETWEEN THE SLIDER AND THE BUTTONHOLE FOOT.
6. TURN THE ADJUSTING SCREW TO THE LEFT UNTIL THE LCD DISPLAY BH SYMBOL.
7. NEXT, TURN THE ADJUSTING SCREW TO THE RIGHT UNTIL THE BH SYMBOL
DISAPPEARS.
8. TURN OFF THE POWER SWITCH.
9. ATTACH THE FACE COVER.
NOTE:
IF THERE IS ANY LINT OR DUST IN THE BUTTONHOLE SENSOR SLIT, LOOSEN THE 2
SCREWS (B) AND CLEAN IT OUT WITH A SWAB.
BH SENSOR
1.6 MM GAP
TO ENTER ADJUSTING
MODE
TURN THE POWER SWITCH ON WHILE PRESSING
THE NEEDLE UP/DOWN BUTTON AND LOCKING
STITCH BUTTON SIMULTANEOUSLY.
PRESS THE START/STOP BUTTON TO
SELECT THE STEP “SC 03”.
SETSCREW (A)
BUTTONHOLE
LEVER GUIDE
BUTTONHOLE
FOOT (R)
BUTTON HOLE LEVER
ADJUSTING SCREW
SCREW(B)
SCREW(B)
