Page 10
Quilt Maker 15 User Manual
2022.02
Installation and Setup
Carriage
You should have your frame set up and ready to go. Refer to the frame manual for detailed instructions
about setting up the frame.
To install the carriage and machine on the frame
1. Place the carriage on the tracks, ensuring that the
stitch regulator faces the back of the frame.
2. Place the machine on the carriage.
U
CAUTION:
It is suggested to have two people
when lifting the Quilt Maker 15. Always lift
from the throat of the machine, not from the
handlebars, needle bar area or needle bar.
3. At the back of the machine, plug the carriage
encoder cable into the round jack on the back of
the machine (to the left of the power cord). Plug
the other end into the encoder.
4. Secure the carriage encoder cable through the clip
at the back of the machine. Check that there is no
strain on the cable at the plug into the machine.
5. Plug the machine encoder cable into the round jack
on the right side of the machine (as seen from the
rear of the machine). Plug the other end into the
encoder.
Â
IMPORTANT:
If you ever need to remove the
machine from the carriage, disconnect the
carriage encoder cable from the carriage
encoder. Failure to unplug the cable when
removing the machine from the carriage
could result in damage to the cable or
carriage encoder.
U
CAUTION:
Never plug or unplug the encoder
cables or any other cables while the quilting
machine is on, as this could potentially cause
electrical damage to the machine or encoders.
Summary of Contents for Quilt Maker 15
Page 1: ...15 Quilting Machine INSTRUCTION MANUAL...
Page 56: ...www janome com...
