janome.com
Page 25
Threading the Needle with the Needle Threader
1. Turn off the power to the machine.
2. Hold the needle threader by the grip, with the triangle mark facing up.
3. Guide the thread, inserting it into the Y groove from right to left horizontally.
4. Place the V groove around the needle, above the eye.
5. Slide the automatic threader down the needle, while pushing it gently against the needle, until
the threader pin goes into the needle eye.
6. Push the grip gently. You should see the threader pin and thread loop at the back of the needle.
7. Remove the threader from the needle slowly, then pick up the loop with the hook on the threader,
pulling the end of the thread out to the back.
8. Turn machine power back on.
To bring Bobbin Thread to the top of the quilt
1. After the machine is threaded, move the machine over the quilt to your
starting location.
2. While firmly holding the tail of the needle thread, press the needle
up/down key (button) twice, causing the needle to go down through the
quilt sandwich and then back to the up position.
3. Move the machine two to three inches while holding the needle thread in place.
he bobbin thread will pull through to the top of the quilt.
4. Grasp the bobbin thread and pull it to the desired length. Reposition the needle to the starting
location. Tie off the threads by quilting a few very tiny stitches while holding both the top and
bobbin thread. Press the Start/Stop key (button) to begin quilting.
To start or stop quilting
•
Start or stop the machine at any time by pressing the Start/Stop key
on the handlebars.
• To start quilting press the Start/Stop key. Do not hold the key down.
• To stop quilting press the same Start/Stop key.
Summary of Contents for Quilt Maker 15
Page 1: ...15 Quilting Machine INSTRUCTION MANUAL...
Page 56: ...www janome com...
