26
www.janome.com
User Manual
QUILT MAKER PRO 16
1. Place the bobbin in the bobbin case so that the
thread pulls off clockwise when viewing the
open side.
2. Slide the thread through the slot and under the
tension spring, leaving approximately fi ve to six
inches of thread hanging loose.
To test bobbin tension
The bobbin tension is the foundati on tension for the enti re machine. Always set the bobbin tension fi rst.
NOTE
: Check the bobbin tension each ti me a new bobbin is inserted.
1. With the bobbin properly in the bobbin case, hold the bobbin case in the palm of your hand with the
open end facing up.
2. Wrap the thread two to three ti mes around the index fi nger of the opposite hand and lift the bobbin up.
The bobbin case should lift up on its side, and slightly lift out of your hand. If the bobbin will not lift up on
its side, the bobbin tension is too loose and if it lift s out of your hand, the bobbin tension is too ti ght.
To adjust the bobbin tension
• Make the bobbin tension adjustment using
the screw in the center of the tension spring.
Turn clockwise to ti ghten and counterclockwise
to loosen the bobbin tension. Make ti ny
adjustments to the bobbin tension and
test again.
