Instruction Manual / Small animal clipper
5
• Just clean the machine dryly with a brush and the cleaning brush.
• Generally, never plunge the clipper and clipperhead into liquids such as water,
soapy water, diesel, petrol, etc. This may cause serious injury to mechanics and
motor.
• Do not switch-on the clipper or the charging station if you suspect liquid to be
penetrated. Hand it over to a service centre.
• Before starting any servicing work, disconnect the power supply; pull the plug
out. Even with the machine switched off, do not handle the area round the clipper
blades as long as the machine is still connected to a power source. Whenever wor-
king on the clipper blades/clipper head, always first disconnect the power supply.
2.6 Animals
WARNING!
The noise of the clipper can trouble animals. A kick, an attack or the weight of the
animal can cause serious injuries. Therefore:
• Just persons being experienced in handling with animals are allowed to clip the
animals.
• Fix and calm the animal sufficiently before clipping.
• Work carefully.
• Unauthorised persons are not permitted to approach the clipping place.
2.7 Battery
WARNING!
Risk of injury when handling incorrectly with batteries!
Rechargeable batteries must be handled with especial care. Therefore:
• Just use original batteries.
• Do not throw the batteries into fire or expose them to high temperatures. There is a
risk of explosion.
• Just use undamaged batteries.
• Never expose the batteries and charging station to solar irradiation and humidity.
• Never short-circuit the battery, because of overheating the battery can blow out.
• Never open the battery. In case of incorrect use, escaping liquid can cause skin irri
-
tation. Avoid any contact with the liquid of the battery. In case of contact wash up
the liquid with a lot of water. If the liquid enters in the eyes, wash out immediately
for 10 minutes and call on a doctor without delay.
ATTENTION!
Reduced durability of batteries when handling incorrectly!
When handling incorrectly, the capacity of the batteries will be reduced. Therefore:
• Just use the original charging station. Other charging stations could destruct the
batteries.
• When not in use for a longer time, separate the charging station from the power
supply.
• Remove the battery and clipper from the charging station, when the station is not
connected to the power supply.
Summary of Contents for 14690 SAPHIR
Page 179: ......
