Mixing Station CLEVER II
with Stirring Device R1900 / R1800
- 11 -
3. PREPARATION
Step 4:
As shown in figure IV,
1.
) take out the inner hexagon screw from the mixer,
2.
) assemble the mixer to the junction plate in order of 1~4 as shown in the diagram and tighten
by the socket hexagon wrench. ( 1-
φspring washing, 2
-
φfalt washing, 3
-junction plate, 4-2mm
washer).
3.
) Put back the junction plate with mixer to the station, tighten the knob.
4.
) Install the paddle to the mixer, use the open-end wrench to lock the mixing paddle and the
mixer in the direction shown
IV
1
2
4
3
