Mixing Station CLEVER II
with Stirring Device R1900 / R1800
- 15 -
4. OPERATION
4.2 STARTING OPERATION AND USE
Improper use may damage the device.
Observe therefore these instructions:
-Use a stirrer up to the specified diameter max Ø 300 mm.
-Load the device in such a way that the speed would not drop considerably or that it
would stop.
Check if the data on the rating plate correspond with the actual mains voltage.
The device´scheduled for 230V can be plugged to 220V/240V mains.
4.3.1 Fixing a stirrer:
Screw tools with thread M14X2 as far as possible in the tool mount and tighten
properly with an open-end wrench (22mm) from among the accessories.
4.3.2 Switching on and off:
By pressing the switch button the device is brought into operation and it stop when is
relieved.
4.3.3 Permanent run:
By pressing the switch button o the stop and simultaneous pressing the arresting pin
permanent run is achieved. By subsequent pressing and relieving of the switch button
the permanent run is interrupted.
4.3.4. Remove the stirrer:
Fit a flat open-end wrench (22mm) on the hexagon end of the tool (whisk) and unscrew
the tool from the spindle by turning it to the left.
