TIGER
BELT-SANDER FOR WOODEN FLOORS
ED 95
PG.
11/16
INSTRUCTION MANUAL
SETTING THE MACHINE UP
In order to start up the machine, proceed as follows:
1.
Familiarize yourself with the machine and read all the danger, warning and caution
instructions. Make sure that all operators have read this manual.
2.
Place the dust bag on the elbow and tie the cord above the flange on the elbow.
3.
Find the power socket. The socket must be compatible with the plug. To avoid danger, the
socket must be earthed and protected with a fuse (20 amp).
4.
Wind the cable around the pig's tail support. Keep the cable out of the machine's way.
5.
Open side guard
9 (fig. C)
.
6.
Lower the tensioning roller by turning lever
10 (fig. C)
clockwise.
7.
Insert the abrasive belt and allow it to protrude from the side by about 2 centimetres.
WARNING:
Only use 750x203 mm abrasive belts.
8.
Stretch the belt by turning lever
10 (fig. C)
anticlockwise.
9.
Put the plug into the socket.
10. Make sure that lever
4 (fig. A)
is hooked up and the roller is off the floor.
11. Turn switch lever
8 (fig. C)
momentarily from position
0
to the
START
position, and bring it
back to
0
(for the start up procedure see pg. 13).
12. Observe the behaviour of the abrasive belt. Follow the "PROCEDURES FOR CENTRING
THE ABRASIVE BELT".
13. Close side guard
9 (fig. C)
.
