- To Turn the Fan ON
press the Power Button and press the “+” button to increase the fan speed:
• Press “+” Once - Low (Digital Display shows F1)
• Press “+” Twice - Medium/Low (Digital Display shows F2)
• Press “+” Three Times - Medium/High (Digital Display shows F3)
• Press “+” Four Times - High (Digital Display shows F4)
- To Delay Power OFF Function
- while the fan is in working mode, press the Timer Button once.
The digital display will blink, press “+” or “-” to increase or decrease delay time duration up to 15
min. The system will automatically shut-off after the chosen time passes.
- To Turn the Light ON/OFF
press the Light On/Off button once.
NOTE: The fan and lights operate independently of each other.
- To Set the Time
, press the Power button to turn On, and then press and hold the Timer Button
until Digital Display starts blinking.
The Hour part will blink (
00
:00)
Adjust the Hour by pressing the “+” for + hrs, or the “-” for - hrs. Once the Hour is correct, press the
Timer button to save and switch to the Minutes.
Set the minutes the same way (using the “+” and “-” buttons for + and - respectively).
Press the Timer button to save time setting.
- Remote Control Sensor:
The remote control sensor receives an infrared (IR) signal from the remote control. The maximum
distance for IR data transmission is 20 feet and requires direct line of sight. The transmission
distance may vary depending on temperature and the remote control battery condition.
Light settings are independent from other settings (including Power Off Delay) and lights have to
be manually turned On/Off.
Note: The Remote Control is powered by CR2025 battery.
00:00
RANGE HOOD USE
Remote
Control
Sensor
Lights
On/Off
Clock/
Timer
Digital
Display
Power
On/Off
Minus
Touch
Button
Plus
Touch
Button
RANGE HOOD CONTROLS:
OPERATING THE RANGE HOOD:
12
