Terminus T3 User Guide JA19-UM
Page 5 Rev: 00 Date: 05/25/17
© Copyright 2017 Janus Remote Communications
Specifications subject to change without notice
All Rights Reserved See website for latest revision. Not intended for life support applications.
T3 Connections continued
Antenna Connections
These are bulkhead antenna connections for wireless communication to cellular and GPS technology.
SMA
Cellular and RX Diversity antenna connections
Pin
Description
Center Pin
Signal
Shield
Ground
MCX
GPS antenna connection
Pin
Description
Center Pin
Signal
Shield
Ground
SIM Card
HSPA910T3 and LTE910T3 Models require a SIM card
The SIM card port is located inside of the T3, on the module itself.
To insert a SIM card, please follow these instructions.
Step 1.
To access the SIM card holder, remove the four TX-10 screws from the ruggedized aluminum enclosure.
These screws are located on the panel of the T3 that includes the RS232 DB9 and RF connections.
Step 2.
Slide out the panel which will include the T3 board.
Step 3.
Locate the SIM card holder on top of the Terminus Plug-In board.
Step 4.
Slide the top of the SIM card holder back to unlock, insert the SIM card and close. Slide back to the original
position to lock back in place.
Step 5.
Slide the panel back into the enclosure, replace, and tighten the four TX-10 screws.
