POTSwap User Guide JA16-EVDO-UM
Page 17 Rev: P07 Date: 08/01/16
© Copyright 2016 Janus Remote Communications
Specifications subject to change without notice
All Rights Reserved See website for latest revision. Not intended for life support applications.
8 Specifications
Interfaces
Parameters
Description
Modem/Telephone
RJ11 connector (FXS)
Serial
DB9 female DCE connector (user terminal interface for configuration and firmware up-
load.
Cellular Antenna
SMA connector, 50 ohms.
GPS Antenna
50 ohm SMA w/ 2.85V bias (on TAGFNG models only)
Power Input
7-15 Vdc; 22W with two input alternatives:
-- 6mm DC power jack with 2mm center pin positive
-- 5.08mm (0.200”) terminal block header (accepts screw clamp
and crimp connector type terminal blocks)
Features
Parameters
Description
SLIC
Performs all BORSCHT functions:
Battery supply to subscriber line
Overvoltage protection
Ringing current supply
Supervision of subscriber terminal
Coder and decoder
Hybrid, 2 wire to 4 wire conversion
Testing
DTMF encoding and decoding
REN=5 at 100 ft. (30m)
Voice
Voice over cellular
Cellular Connection
EVDO910PS model supports CDMA2000, 1xRTT and 1xEVDO
Frequency bands: 800 and 1900 (MHz)
Push Buttons
SELECT, MODE, and RESET
LEDs
Power, Status, Cellular Link and Signal Strength
Dimensions (L x W x D)
6.5 in (165mm) x 5.2 in (132mm) x 1.2 in (30mm)
Weight
15 oz (425 g)
Mounting
Integrated mounting brackets (optional)
Environmental
Parameters
Description
Operating Temperature
-40° C to +60° C (-40° F to 140° F)
(Note: Operating temperature may be further limited by specific Plug-In Terminus terminal)
Relative Humidity
5% to 95% (non-condensing)
