emVIEW-12T/D (
User's Manual
) Installation
3 - 13
Rev. 1.3
© Janz Tec AG
3.2.6
Display
The panel is built as a thin film transistor liquid crystal display TFT-LCD with a diagonal screen of
12.1’’ and up to 16M colours.
Description
Specification
Display area
246.0 x 184.5 mm
Number of dots
800x3 (H) x 600 (V) (RGB vertical stripe)
Pixel Pitch
0.3075 (H) x 0.3075 (V)
Brightness
450 (Cd/m²) typ.
Viewing angles
-80° to 80° (H), -75° to 65° (V) typ.
Backlight
LED
table 5: Display specifications
3.3
Driver installation
If the emVIEW is delivered without touch-screen there are no drivers needed. Using the serial
interface only the
PenMount DMC 9000
driver has to be installed. Is the USB interface used, the
PenMount driver must be installed as well and an auxiliary driver for the USB transceiver chip FT-
232R with virtual COM port (VCP) must be installed. A Linux kernel (newer than version 2.4.20)
contains the VCP driver.
Both drivers are receivable for several operating systems, visit the driver developer homepages:
PenMount:
http://www.penmount.com/down.php
3.3.1
Windows XP driver installation for touch-screen on RS232 or USB
If the touch-screen is connected on the RS232 connector or the USB virtual COM port driver is
installed the PenMount driver has to be installed. It can be downloaded at the address above. The
driver installation is started by clicking the Setup executable in the PenMount folder.
