Zivo
Smart Terminal
TM
36
UM.ZV.1012.01
www.jaotech.com
Commercial in Confidence
APPENDIX
C
Hardware installation
This appendix describes hardware installation.
Sections include:
•
Overview of Hardware installation and upgrading
•
Disassembling the Smart Terminal
TM
•
Installing the 2.5" Hard Disk Drive (HDD)
•
Installing the Central Processing Unit (CPU)
C.1 Overview of Hardware installation and upgrading
The Zivo Smart Terminal
TM
consists of an embedded computer that is housed in a plastic rear
panel and a metal shielding case. The HDD, DDR2 RAM and similar components are all readily
accessible by removing the covers on the rear plastic panel. Any maintenance or hardware
upgrades can be easily completed after removing the rear covers at the back to the terminal.
Note: The colour LCD display installed in the Zivo Smart Terminal
TM
is may contain a
few defective pixels which do not always illuminate. With current LCD technology, it
is almost impossible to guarantee zero defective pixels.
Warning: Do not remove the plastic rear covers until you have verified that no
power is flowing through the Smart Terminal
TM
. Power must be switched off and the
power cord must be unplugged.
C.2 Disassembling the Zivo Smart Terminal
TM
The following is the standard procedure for disassembling the Zivo Smart Terminal
TM
to
upgrade your system. All procedures are illustrated in Figure C.1.
Figure C.1: Disassembling the plastic rear cover of the Zivo
Unscrew the screws that secure the plastic rear covers, and then remove the covers