105
105
13.3 SUPERVISOR USING
In case on J3500 the SUPERVISOR is used to give the possibility to control and to execute
operations delicate, the SUPERVISOR will be able to be replace, also during a receipt
, normal clerk
and to execute the operation in object in order to give again at the operation end, the
continuation of the receipt to the clerk that had begun it.
As an example the SUPERVISOR can replace the clerk that isn't allowed to execute E.C.
operations, SUPERVISOR can execute the E.C. operation and at the end to give back the
continuation of the receipt to previous clerk.
The operations that can be limited in selective mode for each Clerk are:
-
E.C.
-
VOID
- % 1
- P/O 1
- % 2
- P/O 2
- % 3
- P/O 3
- (+)
- Transaction void
- (-)
- R.M.
The SUPERVISOR can replace himself to the Clerk during a receipt.
In the following examples the execution of an operation of E.C. from the SUPERVISOR.
13.3.1 Clerks and SUPERVISOR by codes :
- After the several registrations executed by the Clerk, at the attempt from the same one
to execute the operation to which he isn't allowed, the ECR will signal the lack of
qualification by the error E171 - Non authorized.
- To remove the error by CL key.
- To press the Clerk key.
- To input the SUPERVISOR's code (Eg.: 123456).
- To press the Clerk key again.
- To press the E.C. key.
- To continue with the other registrations.
Note: The SUPERVISOR can replace itself to the Clerk in order to execute all the
operations delicate indicated above, the SUPERVISOR code will be necessary
also in order to set the ECR in Prg. mode instead than the procedure (4)--Key.
Summary of Contents for J3500E
Page 55: ...49 49 ...
