59
59
10.4 PROGRAMMING
READING
REPORT
X (Report Code) TOTAL1
KEY
Report Code : see below table
CODE
REPORT
TYPE
901
Departments
Programming
902
System parameters 1 Programming
903
PLU
Programming
904
PB
Programming
905
System parameters 2 Programming
906
Not
used
907
Keyboard layout Programming
908
Memory
configuration
913
2
nd
language Programming (if existing)
914
PLU
Arrangement
Programming
921
Sequential PLU Programming
922
Sequential
PB
Programming
Report code 921 and 922 activation procedure :
X (COD) TOTAL1 (I° Cod.) TOTAL1 (II° Cod.) TOTAL1
KEY
COD
: Report Code (see above table)
I° Cod. : Code of the first PLU or PB of the group for which it is
desired to obtain the Programming report
II° Cod. : Code of the last PLU or PB of the group for which it is
desired to obtain the programming report
Note:
The manual input of PLU codes can be replaced from the reading through the
scanner of the bar-code of the product or from the pression of direct Hard PLU
Key.
10.4.1 SPECIFIC PROGRAMMING READING REPORT
"Specific" Reports
(Function Key) #/NS
KEY
Example: to read the programming of : "%2", of "TOT. 3" and of "Dept. 5":
“P”---- press "%2"---- press "TOT.3"------ press "Dept.5"------ close with "#/Ns"
Programming reading for each kind of Programming
a) "Prg" mode
b) Input the Code used in order to activate the Programming (see paragraphs
7.XX in this manual)
c) press the key “X/time”
d) press the key "SUB-TOTAL"
e) close with the key "#/NS".
Eg. : In order to obtain the printing of the SCOM port assignment programming :
P (95) X/time SUB-TOT.(R) #/NS
KEY
P
Summary of Contents for J3500E
Page 55: ...49 49 ...