5-37
Section 5
Web Interface
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
The area setting procedure is as follows.
1
When the area is set as a transmission prohibition area, select [TX Limitation] from
the [Function] combo box of desired No..
2
When the area is set as a blocking area, select [Blockage Indication] from the
[Function] combo box of desired No..
Do not set a check mark when setting the area as a blocking area.
3
Set a range.
EL Max
EL Min
BR Begin
BR End
Input an upper limit
angle of EL within the
range from -20 to 90.
Input a lower limit
angle of EL within the
range from -20 to 90.
Input a starting angle
of BR within the
range from 0 to 359.
Input an ending
angle of BR within
the range from 0 to
359.
4
Repeat steps 1 to 3 as required.
5
Save/apply the setting by clicking on the [Set] button after setting.
The setting result is displayed in the Blockage Area Diagram.
Summary of Contents for JUE-60KA
