jaquar Smart Vapour 0015, Manual For Installation And Use

- 3 -

IMPORTANT !!

Consult the technical data sheet of the 
product to be installed.

For the system to operate correctly the feed 
water must not contain impurities (sand, 
rust, etc.) and must have a pressure ranging 
from  1.5 to 3 bar.

We suggest the installation of a  100 
micron feed water filter and of a water 
softener.

Before positioning the product

,

it is the 

duty of whoever assembles the product to 
check that all the connections are watertight. 

This guarantee is not valid if there are 
leaks after the product has been installed.

SAFETY
DISTANCES

Shower areas, saunas, bathrooms, swimming 
pools and the surrounding areas are classi-
fied by EN safety standards as special zones, 
since the humidity and dampness associated 
with these areas can make them extremely 
dangerous.
The standards specify four clearly-defined 
areas:
zone 0, 1, 2 and 3.

The omnipolar switch with opening of 
contacts of at least 3.5 mm must be located 
outside of these zones, distant from possible 
contact with water.

The limits of the various danger zones may be 
modified by the presence of walls, protective 
panels and fixed insulating walls which limit 
access to the tub or to the shower plate.

In this case, the area is delimited by taking a 
piece of string whose length is that of the area 
and winding it around the wall to the opposite 
side. The path taken by the end of the string 
marks the danger zone.

The zones that are external to the four danger 
areas are considered to be normal.

PRECAUTIONS

The material used for the construction of 
the product  is extremely tough and durable, 
which is demonstrated by the widespread use 
of this material in many industries.
However, this material may be damaged by 
certain chemical substances such as acetones 
and solvents in general, and stained by 
alcohol-based liquids if these are not removed 
immediately.
For this reason, it is advisable to protect the 
product with paper or cardboard (the packing 
cartons may also be used) during installation, 
in order to ensure that no abrasive substances 
or paint come into contact with the surface.

It is also advisable to avoid placing tools on 
the surface of the product.

Before installing the product, check it 
with care.
Any damage of defects found after the 
product has been installed will not be 
covered by the guarantee.

Immediately on delivery, check that the ap-
pliance is in perfect condition and that the 
packaging is not damaged in any way.

When moving the product, always grip the 
edges or the frame. Ensure that the pipes are 
not damaged when moving the tub.

Never lift or move the product by its pipes 
(or by the steam dispenser).

60 cm

60 cm

240 cm

240 cm

225 cm

3

3

2

2

1

0