99
5. Within these approx. 5 seconds, press the
UP and DOWN
button
at the same
time
and then immediately press the
STOP
button of your transmitter.
UP and DOWN
STOP
6. The motor vibrates briefly, the transmitter has been taught in again. The direction of rotation of the
motor has changed.
Setting the end points / end positions
First set the
lower end point
.
1. Move the roller shutter shaft (without curtain) to a posi-
tion that allows you to fasten the steel strip hangers in the
hanging openings of the shaft.
To do this, press the DOWN button on your transmitter and
observe the rotation of the shaft.
As soon as the shaft has reached the necessary position for
hanging the steel strip hangers, press the STOP button.
2. Hang the curtain with the steel strip hangers onto the
shaft.
3. Correct the lower end point with the UP/DOWN and STOP
buttons if necessary.
4. Press the
UP
and
DOWN
buttons on the transmitter
at the
same time
.
5. Then press the
STOP
button
2x
.
6. Press the
DOWN
button briefly within 10 seconds.
The motor will confirm the setting of the lower end point
by vibrating briefly.
UP and DOWN
2 x STOP
1 x DOWN
Be sure that only the
corresponding motor
is ready to learn!
EINSTELLUNGEN
SETTINGS / PARAMÈTRES / AJUSTES / IMPOSTAZIONI / INSTELLINGEN /
USTAWIENIA / AYARLAR
