Model Buster IX
page 3 of 20
JARVIS
®
6206026
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457--4926
UNITED STATES OF AMERICA E--MAIL.
jarvis.products.corp@snet.net
TEL. 860--347--7271 FAX. 860--347--6978 WWW
.jarvisproducts.com
notice to operators, maintenance
and cleanup personnel
1. Disconnect
the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before making any blade changes.
2. Disconnect
the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before performing any repairs or maintenance.
3. Disconnect
the power supply -- or have the power supply disconnected -- in accordance with OSHA’s
lockout/tagout procedures (29 CFR 1910.147) before performing any cleanup.
4. Disconnect
the power supply when the tool is not in use.
5. Never
put fingers, hands or other parts of the body on the cutting edge or within the cutting path of the
tool when it is connected to the power supply.
6. Test
the tool prior to use or daily.
Depress
each trigger separately and the tool should not start.
Depress
one trigger, then pause one second and depress the other trigger and the tool should not start.
Repeat
this procedure reversing the triggers.
Depress
both triggers simultaneously and the tool should start.
With the tool running, release one trigger and the tool should stop.
Continue
holding the depressed
trigger and then depress the other trigger. The tool should not start.
Repeat
this procedure holding
the other trigger.
If the tool malfunctions, remove it from service and report or repair it immediately
.
7. Test
the door interlocks prior to use or daily.
Open
both the idler and drive end doors individually be-
fore depressing both triggers simultaneously. The tool should not start with either or both doors open.
If the tool malfunctions, remove it from service and report or repair it immediately.
8. Never
depress the triggers unless you want to use or test the tool.
9. Never
make modifications or alterations to the tool.
Report or replace any missing or illegible labels.
10. Never
remove any safety devices on the tool.
NOTICE TO OPERATORS, MAINTENANCE AND CLEANUP PERSONNEL
REMOVE ANY MALFUNCTIONING TOOL FROM SERVICE
REPORT ANY PROBLEMS TO YOUR SUPERVISOR
Keep hands clear.
