pg 3 of 8
MODEL 400
JARVIS
6205005::::
®
1. Disconnect
the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before changing the blade.
2. Disconnect
the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before performing any repair or maintenance.
3. Disconnect
the power supply -- or have the power supply disconnected -- in accordance with OSHA’s
lockout/tagout procedures (29 CFR 1910.147) before performing any cleanup.
4. Disconnect
the power supply when the tool is not in use.
5. Always
wear eye protection in accordance with OSHA’s eye and face protection requirements (29
CFR 1910.133), and when needed, a dust mask.
6. Do not
operate near flammable liquids or in gaseous atmospheres.
7. Do not
operate in outdoor locations or in damp or wet locations.
8. Do not
overreach; keep proper footing and balance when using the tool.
9. Never
put fingers, hands or other parts of the body on the cutting edge of the blade or in the cutting
path.
10. Always
use both hands when starting and operating the tool to avoid the risk of possible “kick back”
or “recoil.” Continue holding the tool with both hands until the saw blade comes to a complete stop.
11. Test
the tool prior to use or daily.
Depress
the trigger and the tool should start.
Release
the trigger
and the tool should stop.
If the tool malfunctions, remove it from service and report or repair it im-
mediately
.
12. Never
depress the trigger unless you are going to use or test the tool.
13. Never
make any alterations to the tool.
Report or replace any missing or illegible labels.
SAFETY MESSAGES TO OPERATORS, MAINTENANCE AND CLEANUP
PERSONNEL
REMOVE ANY MALFUNCTIONING TOOL FROM SERVICE
REPORT ANY PROBLEMS TO YOUR SUPERVISOR
Keep hands clear.
safety messages to operators,
maintenance and cleanup personnel
Cutlerymania.com is an authorized online parts distributor supplying
Original Jarvis Products. .
E-mail: info@cutlerymania.com
FAX: 973-751-7701 Telf: 973-751-7775 www.cutlerymania.com
