3
Battery Installation
1. On the back of the remote, push down on the tab
and lift the cover off.
2. Match the batteries to the + and - marks inside the
battery case, then insert 2 AAA Alkaline batteries.
3. Press the battery cover back into place.
Battery Saver
Your remote automatically turns off if the buttons
are depressed more than 30 seconds. This will save
your batteries should your remote get stuck in a place
where the buttons remain depressed (e.g., between
the sofa cushions).
Code Saver
You will have up to 10 minutes to change the
batteries in your remote without losing codes you
have programmed. However, do not press any
buttons until batteries are installed in the remote. If
buttons are pressed without batteries in the remote,
all codes will be lost.
Code Setup
The
SETUP button is used to setup the remote. You
can either setup the remote using the code tables (on
separate sheet), or you can search through the library
of codes until you find a code that works for your
product. Please refer to “ Code Search” on page 7 for
more information on using the code search feature to
learn how to search through the library of codes for
your products.
NOTE: You can store any kind of code under any
mode (except TV). I.E. you can store a DVR code
under the
CBL/SAT button, or a Cable code under the
DVD/DVR button, etc. However, you can only store TV
codes under the
TV button.
Setup
