28
USER SET UP
Before starting any welding activity ensure that you have suitable eye protection and
protective clothing. Also take the necessary steps to protect any personnel within the
welding area.
Please note: The following should only be carried out by the authorised operator.
Air pressure setting
The external air pressure regulator is mounted on the machines rear panel and is only present and used
when workshop compressed air is connected.
Checking and testing air quality should be carried out periodical as adjustment can often be required,
this process is easily carried out following the instructions below:
Image 1
Image 2
Image 3
1.
Ensure the plasma torch is securely in
place (see page 27).
2.
Connect the workshop air supply to the machine via the air regulator inlet (A) mounted on the rear
panel (image 1).
3.
Connect the machine to the mains supply and switch the machine ON (located on the rear panel
the
machine (see pages 13 and 16).
4.
Depending on which control panel your machine has, activate the test air option which will then
activate air purging to start the air flow through the machine and plasma torch (refer to pages 15 or
20 for further information).
5.
Using your fingers, lift up the pressure control knob (B) of the pressure regulator to
‘
unlock
’
it shown
in image 2.
6.
Now (if required) adjust the air pressure by rotating the knob (B) in either clockwise direction to
increase the air pressure setting or anticlockwise to reduce the pressure which will be noted on the
pressure gauge.
7.
When the correct air pressure is set on the regulator gauge, push down the adjusting knob (B) in
image 3 to lock it.
Please Note:
Any water which has been collected by the air regulator will be drained by the auto drain of the
regulator when the airline is connected.
Always ensure that your compressed air supply is clean and dry, this can be achieved by installing air
filters and air driers as required.
Due to condensation build up in supply pipes from the compressor, its good practice to always have
an air filter and/or air drier mounted inline at the outlet (connection point) for the plasma machine.
Summary of Contents for EVO 2.0 EP-45
Page 1: ...1 ClearVision Optional TFT LCD screen included...
Page 44: ...44 UKCA Declaration of Conformity...
Page 45: ...45 EC DECLARATION OF CONFORMITY...
Page 50: ...50...
