32
OPERATION
-
MODES OF CUTTING
Before starting any welding activity ensure that you have suitable eye protection and
protective clothing. Also take the necessary steps to protect any personnel within the
welding area.
Modes of cutting
The images below show two different ways by using different consumable configurations that allows the
operator to cut material with the plasma torch.
See page 34 for the full consumable selection options for the supplied plasma torch.
Drag Tip Cutting
Drag tip cutting is the process of dragging the tip of the torch along the workpiece to cut the metal.
This is often the easiest way to cut while minimizing heat input but usually only on cutting currents of
40/45 amps and below. This technique works best when the material being cut is 5mm or less.
Drag tip cutting does require a
‘
drag
’
cutting tip and you need to ensure that the plasma machines output
amperage is matched to the amperage with the cutting tip.
It can often be helpful to use a non
-
conductive straight edge to help maintain a straight cut.
Drag Shield Cap Cutting
The drag shield cap option allows the same technique to be used but having the cutting tip insulated
(shielded) from the material being cut. Using a drag shield cap allows you to rest the torch (via the drag
cap) on the workpiece while maintaining an optimal 2~3mm standoff without touching the cutting tip to
the material for amperages of 40amps and above. (When cutting at above 40amps, touching the tip to
the work material will adversely affect your cut quality and consumable life).
When you start to drag cut, you would place the tip/cap of the torch on the workpiece and begin dragging
(moving) the torch across the workpiece. You should always start with the torch placed at the farthest
point from you and then cut by pulling the torch towards you while making sure to keep the torch upright
to the material being cut throughout the cutting process.
As you are drag cutting ensure you maintain a smooth and consistent travel speed to make a clean,
precise cut.
The main benefits of drag cutting is:
Much easier for the operator because you don't need to maintain a distance between the cutting
tip and the workpiece. You can simply drag the end of the plasma torch along a template or a
straight edge. This process usually ensures a more accurate cut.
Drag cutting produces less spatter and blow back and improves the life of the front end torch parts.
Best cut quality for material of 5mm or less.
Drag Tip Cutting
Drag Cap Cutting
Summary of Contents for EVO 2.0 EP-45
Page 1: ...1 ClearVision Optional TFT LCD screen included...
Page 44: ...44 UKCA Declaration of Conformity...
Page 45: ...45 EC DECLARATION OF CONFORMITY...
Page 50: ...50...
