Jasic JT-300P-WC Assembly Instructions Manual Download

Page: 3 / 8

TIG TROLLEY COMPATABILITY

These assembly instructions are suitable for the following Jasic TIG welding packages:

202A

202D

300P

315MWD

CONTENTS

Check the trolley packaging for any signs of damage.

Carefully remove all the components, check that all parts are present and retain the packaging until the
assembly is complete.

Kit Contents:

1 x Base Unit (assembled)

2 x Cylinder Chain/Straps

2 x Side fixing brackets

1 x Upright Cylinder Support

2 x Top Shelf Brackets

1 x Top unit (with handle)

6 x M5 Screws

10 x M10 Screws

12 x M6 Screws

Please Note:

This kit is used for other machine packages, you may note that extra screws are supplied and

as a result there may be some screws left over once you have fully assembled the trolley package.

For the following instructions we have used the Jasic JT

315 ACDC Multi Wave TIG power source and

cooler as shown below.

Summary of Contents for JT-300P-WC

Page 1: ......

Page 4: ...tents of the TIG trolley assembly kit Various sundry items required for assembly Base unit item 1 including assembled wheels Upright Cylinder Support item 3 Side fixing brackets item 4 Top shelf item 2 also showing circled top shelf brackets ...

Page 6: ...crews C 7 Remove the bottom side front and rear screws either side of the power source the middle screw may not be required to be removed and mount the power source on top of the water cooler lining up the holes of the bracket The bracket should be on the outside of the power source panel Secure the power source with the screws that were removed ...

Page 8: ...8 July 2021 Issue 1 ...