10
P150LT Plasma Hand Torch
Fitting the P150LT plasma torch
On the Jasic Cut 100 plasma machine, the below torch fitting instructions will need to be observed.
•
Locate plasma torch plug into euro connector socket as shown in image (Fig 1) below
•
While using the key provided (Fig 6)
•
Push and hold in button in (Fig 2) whilst at the same time rotate nut on torch clockwise until fully connected and tight as
shown in Fig 3
•
Fig 4 shows the torch screwed in correctly
•
Fig 5 shows the torch not fully connected preset
Fig 6
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5
Push button
Wilkinson Star Technical
