11
CONTROLS
Front view Jasic TIG 180 & 200
1.
Overheating LED: Indicates overheating, when this LED
is on it indicates that the temperature inside the
machine is too high and the machine is under
overheating protection status
2.
Power LED: Indicates that power is present at the
machine and that the power switch of the machine
is on
3. Downslope time control: 1~10s
4. Post flow time control: 1~10s
5. "+" Output terminal*: To connect the work clamp
6.
"
-
" Output terminal*: To connect the TIG torch
7.
Gas terminal: To connect the gas hose of the TIG torch
8.
Control terminal: To connect the trigger switch plug
of the TIG torch trigger
9.
Front grill for air intake
10.
MMA/TIG switch: To toggle between MMA and TIG
11.
2T/4T switch: When the toggle switch is switched to 4T, self
-
lock function is available
12. Welding current knob: To adjust the output current
* Panel socket size is 35/50mm
Rear view Jasic TIG 180 & 200
13. Gas inlet connector
14. Power ON/OFF switch
15. Mains power cable
16. Rear panel grill and cooling fan
13