Connectingthearm cables
Fix cable connector
Please refer to the steps shown in the following
pictures to fix the tonearm cable connector.
Connect tonearmcable
Cartridge set up
Jasmine JS-TA297 tonearm come with a dedicated
cartridge setup protractor.
Step 1: Adjust VTA , Vertical Tracking Angle
(VTA) describes the angle between a line, from
cantilever pivot to stylus contact area, and the
record surface. While this angle is manufactured
into the cartridge, VTA will require setting when
installing the phono cartridge to a tonearm. On a
pivoting tonearm, a final VTA setting may be
arrived at by raising or lowering the tonearm at it's
base mounting. Raising the entire tonearm will
increase VTA, lowering will decrease VTA.
Usually, the VTA will be OK when the tonearm
wand is parallel to the surface of the vinyl.
Step 2: Place the protractor, According to the
instructions on the protractor, place the protractor
properly, and please pay attention to whether the
straight line pointing to the arm pivot is aligned or
not.
