Jason International, Inc. •
501.771.4477
Page 10 of 26
Customer Service : 800.255.5766
Copyright © 2014 Jason International, Inc.
INSTALLATION INSTRUCTIONS (cont.)
Figure 13b
4. Place the equipment inside the frame and attach all
the plumbing and electrical connections. See Figure
14a for AirMasseur
®
and 14b for MicroSilk
®
baths.
Note: The electrical service can be provided inside or
outside the enclosure. Refer to the ELECTRICAL section
of this manual for service requirements. If the service is
outside the cabinet, position cord through the slot provided
in the frame and enclosure.
5. For MicroSilk baths, clamp the plumbing lines to the
appropriate barb using the clamp provided. Assure
the line will allow proper drainage to the bath fitting. The
hose must have a continuous drop from the barb to the
fitting. See Figure 14c.
Figure 14b
Figure 14c
6. Refer to faucet manufacturer’s installation instruc-
tions if a faucet is intended to be mounted on the top of
the cabinet and position the plumbing stub outs inside the
cabinet.
Caution: Use long enough stainless steel flexible
hose to lift the enclosure up to provide access for
disassembly in the future. Be sure to install a faucet
that will reach the well of the bath from the enclosure.
Refer to the bath specification sheet for deck width
dimensions.
7. Fill the bath and test all connections for leaks.
8. Place cabinet on the frame and attach with the four (4)
screws and decorative caps.
Figure 14a
