Jason International, Inc. •
501.771.4477
Page 12 of 26
Customer Service : 800.255.5766
Copyright © 2014 Jason International, Inc.
INSTALLATION INSTRUCTIONS (cont.)
AIRMASSEUR
®
ContRol box ConnECtIonS
sTanDarD eDITIOn aIrMasseur
®
Jason’s Standard Edition AirMasseur
®
system features
the best in luxury bathing for the leisure bath industry. To
assure that your bath functions properly the blower control
must be properly connected.
NOTE: For 120V systems, the power cord for the blower
control box must be plugged into a 120V, 15 amp, GFCI
dedicated circuit.
Figure 15
Blower
C
IMC-213
Keypad
B
A
To Dedicated
120V / 60Hz 15A
GFCI Protected Service
C
Control Box
NOTE: This diagram also applies to 50 Hz, 240V controls,
and power supply systems. Except that the Blower junction
box must be connected into one dedicated 240V, 15 amp,
GFCI circuit.
The AirMasseur® Control Box
The blower and keypad must be plugged into the proper
receptacles for correct operation of the AirMasseur
®
system.
See Figure 15 for connections:
(A) The power cord for the AirMasseur
®
control box must
be connected into the proper GFCI dedicated circuit for the
system (see note).
(B) The blower’s power cord will need to be plugged into the
control box Refer to the ELECTRICAL section of this manual
for connecting the pump to the control box.
(C) Eight-pin mini-DIN terminal for the AirMasseur
®
Keypad.