Jason International, Inc. •
501.771.4477
Page 14 of 26
Customer Service : 800.255.5766
Copyright © 2014 Jason International, Inc.
INSTALLATION INSTRUCTIONS (cont.)
sIgnaTure eDITIOn aIrMasseur
®
Jason’s Signature Edition AirMasseur
®
system is the most
advanced bath manufactured by Jason International, Inc.
and features the ultimate in luxury bathing for the leisure
bath industry. The blower control box must be properly
connected for the bath to function correctly.
NOTE: For 120V systems, the power cord for the blower
control box must be plugged into a 120V, 15 amp, GFCI
dedicated circuit.
Figure 17
Blower
D
C
Ozone
IMC-213
LEDs
Keypad
B
A
To Dedicated
120V / 60Hz 15A
GFCI Protected Service
C
D
E
Water/
Temp
Sensor
Remote
E
Control Box
The AirMasseur® Control Box
The blower, keypad, LED light, Ozone Sanitation Unit and
Water Level/Temperature Sensor must be plugged into the
proper receptacles for correct operation of the AirMasseur
®
system. See Figure 17 for connections:
(A) The power cord for the AirMasseur
®
control box must
be connected into the proper GFCI dedicated circuit for the
system (see note).
(B) The blower’s power cord should be plugged into the
female cord connection on the ozone unit, prewired to the
control box.
(C) Eight-pin mini-DIN terminal for the AirMasseur
®
Keypad.
(D) Six-pin mini-DIN terminal for LED light.
(E) Six-pin mini-DIN terminal for installation of the water
sensor to the control box.
NOTE: This diagram also applies to 50 Hz, 240V controls,
and power supply systems. Except that the Blower junction
box must be connected into one dedicated 240V, 15 amp,
GFCI circuit.
