Jason International, Inc. •
501.771.4477
Page 17 of 26
Customer Service : 800.255.5766
Copyright © 2014 Jason International, Inc.
CONTROL bOx CONNeCTIONS (cont.)
sIgnaTure eDITIOn MICrOsIlK
®
Jason’s Signature Edition MicroSilk
®
system is the most
advanced bath manufactured by Jason International, Inc.
and features the ultimate in luxury bathing for the leisure
bath industry. The MicroSilk
®
control box must be properly
connected for the bath to function correctly.
NOTE: For 120V systems, the power cord for the
MicroSilk
®
control box must be plugged into a 120V,
20 amp, GFCI dedicated circuit.
Figure 20
LEDs
Ozone
MS
Pump
MS Signature 2014
A
To Dedicated
120V / 60Hz 20A
GFCI Protected Service
Control Box
Keypad
C
D
B
E D
C
IMC-213
E
Water/
Temp
Sensor
Remote
The MicroSilk
®
Control Box
The MicroSilk
®
unit, keypad, LED light, Ozone Sanitation Unit
and Water Level/Temperature Sensor must be plugged into
the proper receptacles for correct operation of the MicroSilk
®
system. See Figure 20 for connections:
(A) The power cord for the MicroSilk
®
control box must be
connected into the proper GFCI dedicated circuit for the
system (see note).
(B) The MicroSilk
®
pump’s power cord should be plugged
into the female cord connection on the ozone unit, prewired
to the control box.
(C) Eight-pin mini-DIN terminal for the MicroSilk
®
Keypad.
(D) Six-pin mini-DIN terminal for LED light.
(E) Six-pin mini-DIN terminal for installation of the water
sensor to the MicroSilk
®
control box.
NOTe:
This diagram also applies to 50 Hz, 240V pumps, controls,
and power supply systems. Except that the MicroSilk
®
Pump
junction boxes must be connected into one dedicated 240V, 20
amp, GFCI circuit.
