Jason International, Inc. •
501.771.4477
Page 10 of 16
Customer Service : 800.255.5766
Copyright © 2011 Jason International.
OPERATING INSTRUCTION, FEATURES, ANd CONTROLS
INTROdUCTION
This manual contains all information needed for the proper
installation and operation of your Jason AirMasseur
®
bath.
The AirMasseur
®
bath has been designed to give you years of
relaxing trouble-free service, provided the unit is maintained
and operated in accordance with these instructions.
Thoroughly clean and disinfect the unit as described in the
ClEaNINg
section of the
uSER maINtENaNCE INStRuCtIONS
section of this owner’s manual before its first use and
periodically thereafter.
All Jason air baths are pre-plumbed at the factory.
WaRNINg: before operating refer to the instructions pertaining to the
risk of fire, electric shock, or injury to persons.
FEAtURES AnD ContRolS
STANdARd ANd PREMIER EdITION AIRMASSEUR
®
The Jason Standard Edition AirMasseur
®
bath includes a
variable-speed, 1-HP air blower with heater, automatic purge
cycle; and three (3) massage modes: Continuous, Wave, or
Pulse; an electronic control; and a 20-minute timer.
The Jason Premier Edition AirMasseur
®
bath provides all the
features of the Standard Edition with the included benefits of
a LED Chromatherapy Mood Light, and an Ozone Sanitation
system.
Standard/Premier Touchpad
One main control touchpad mounted on the bath deck contains
several icons used by the bather to control the blower, and LED
mood light. A built in timer shuts the blower off 20 minutes after
being activated.
Standard/Premier Automatic Purge
Fifteen (15) minutes after the control has shut off and the bath is
completely drained, the blower will start again for a two-minute
purge cycle that dries the air channel. Note that the blower light
will flash during the 15-minute pause before the purge cycle
begins. Once the purge cycle begins, all indicators will light and
the keypad operation will be disabled for two (2) minutes.
SIGNATURE EdITION AIRMASSEUR
®
The Jason Signature Edition AirMasseur
®
bath includes a
variable-speed, 1-HP air blower with heater, automatic purge
cycle; and three (3) massage modes: Continuous, Wave, or
Pulse; Chromatherapy mood light, Automatic Ozone System
that will be operated any time the blower is powered; a digital
control with LCD display window; low water and temperature
sensors; and a 20-minute timer.
SIGnAtURE EDItIon AIRMASSEUR
®
Jason’s Signature Edition AirMasseur
®
system is the most
advanced bath manufactured by Jason International, Inc.
and features the ultimate in luxury bathing for the leisure
bath industry. The blower control box must be properly
connected for the bath to function correctly.
THE BLOwER CONTROL BOX
The blower, keypad, LED light, ozone sanitation unit, and
water level/temperature sensor must be plugged into the
proper receptacle for correct operation of the AirMasseur
®
system. See
Figure 14
for connections: (A) The junction box
for the blower control box must be connected into a 240v, 15
amp GFCI dedicated circuit. (B) Pre-wired power cords to
blower (C) and ozone unit (G). Eight-pin mini-DIN terminal
for installation of AirMasseur
®
keypad (F). Six-pin mini-DIN
terminals for the water/temperature sensor (D), and LED
light (E) to the blower control box.
SIGNATURE EdITION AIRMASSEUR
®
PARTS LIST
Blower
Blower Control Box
Keypad
Keypad Cable
Control Box Stand
Water Level/Temp Sensor
LED Light Assembly
LED Light Cable
Ozone Sanitation Unit
Figure 14
NOTE: This diagram (Figure 14) also applies to 50Hz, 240V
controls, and power supply systems.
