Jason International, Inc. •
501.771.4477
Page of 15
Customer Service : 800.255.5766
8. After the finished floor is installed, position the installation
template on the finished floor. Place the template to line up
with the existing floor drain location and orient the template
to the desired position.
NOTe:
Sump area location cutout;
remote blower tubing floor location cutout; and water inlet
stubout location must line up with the template. Transfer the
centerlines of the template to the finished floor.
(CauTION:
use a marker that can be removed from the finished floor
after installation). Tape the template to the finished floor
using care to align both centerlines and assure that the
template is laying flat on the floor.
9. Drill the 1/4” pilot holes for the two indicated centerline
mounting holes if installing on a wooden floor. 5/16” holes
are required for a cement slab floor.
(See Figure 3.)
10.Dry fit the drain and overflow to the bath. Use the
instructions included with the drain and overflow to
determine the proper fit to the bath.
NOTe:
It is recommended
that the Geberit drain and overflow model #150.176 be used. If
any other drain is used, it may not conform to these instructions.
(Drain Not Included.) This drain can be purchased from
Figure 3
any authorized Jason International, Inc. dealer. Position
the bath in place and attach the drain and overflow to
the floor drain “P” trap.
(CauTION:
Only dry fit the drain
and overflow tee to the “P” trap at this time). Disconnect
the drain and overflow from the bath and leave the drain
assembly free standing in the “P” trap.
11.Align the drain with the centerline on the template.
(see
Figure 4.)
12.Permanently attach the drain tee to the “P” trap.
13.Remove the template from the floor.
14.Place the bath skirt into position and attach to the floor by
aligning the two (2) center-line holes in the bottom of the
skirt with the pre-drilled holes in the floor. Attach to the
floor with a 5/16” x 2-1/2” lag screw and a 5/16” x 1-1/2”
fender washer when installing into a wood floor or 5/16”
concrete anchors and a 5/16” x 1-1/2” fender washer when
installing into a concrete slab floor.
(Fasteners not included.)
CAUTION: Do not over tighten
.
Figure 4
INSTALLATION INSTRUCTIONS (cont.)
