Jason International, Inc. •
501.771.4477
Page 18 of 24
Customer Service : 800.255.5766
Copyright © 2013 Jason International.
MICROSILK
®
OPERATION
STANDARD AND PREMIER EDITION MICROSILK
®
The Jason Standard Edition MicroSilk
®
bath includes a
Microbubble generator unit, an electronic control, and a
20-minute timer.
The Jason Premier Edition MicroSilk
®
bath provides all the
features of the Standard Edition with the included benefits
of an LED Chromatherapy Mood Light, and an Ozone
Sanitation system.
Standard/Premier Touchpad
One main control touchpad mounted on the bath deck
features several icons used by the bather to control the
MicroSilk
®
unit and LED mood light. A built-in timer shuts
the pump off 20 minutes after being activated.
SIGNATURE EDITION MICROSILK
®
The Jason Signature Edition MicroSilk bath includes a
Microbubble generator unit; Chromatherapy mood light,
Automatic Ozone System that will be operated any time
the pump is powered; a digital control with LCD-display
window; low water and temperature sensors;
and a 20-minute timer.
Signature Touchpad
A main control touchpad mounted on the bath deck fea-
tures an LCD readout which alternately indicates the water
temperature (+/- 5° F) and time remaining. The Signature
Edition touchpad allows the bather to control the MicroSilk
®
pump and LED mood light. A built-in timer shuts off the
pump 20 minutes after being activated.
OPERATING INSTRUCTIONS, FEATURES, AND CONTROLS (cont.)
Signature Remote Control
In addition to the main control touchpad installed on the
bath deck, a floating, waterproof Universal Remote Control
is provided with all Signature Edition MicroSilk
®
baths. This
remote control provides the same control functions as the
bath’s main control console, plus the bather may remotely
operate a TV, DVD, VCR, CD, etc. Refer to the Instruc-
tion Manual provided with the remote control for detailed
instructions.
Port
A strategically placed MicroSilk
®
port is provided for com-
plete enjoyment of your bath.
MicroSilk
®
Unit
The MicroSilk
®
unit generates oxygen-rich microbubbles
that fill the bath. MicroSilk
®
units provided on Jason baths
are factory tested when assembled and again retested
after installation on the bath.
Filling and Draining
Close the drain and fill the bath with water at least two (2)
inches (50mm) above the jet. The inlet temperature should
not exceed 104°F (40°C). When bath is in use, turn the unit
Off before draining the water. The bath unit and its plumb-
ing are designed to drain after each use whether used as a
hydrotherapy bath, soaking bath, or just taking a shower.
NOTE: If the unit fails to operate, check the breaker
panel to ensure that the circuit breaker is on. Check
the GFCI by testing and resetting it. Also check the
water level in the bath; it must be above the water
level sensor located on the sidewall of the bath for the
pump to operate. If the unit still fails to operate, refer
to the Trouble Shooting Guide section of this manual.
If the unit still fails to operate and is out of warranty,
contact an authorized service technician for repair.
If the unit is within the warranty period,
contact JASON Technical Services at 800-255-5766.
DO NOT ATTEMPT TO RESOLVE THE PROBLEM.
