Jason International, Inc. •
501.771.4477
Page 6 of 8
Customer Service : 800.255.5766
Copyright © 2011 Jason International.
INSTALLATION INSTRUCTIONS (cont.)
CLEANING
1.
Remove all loose debris.
Construction plaster or excess
grout can be removed with the use of a wood (edge)
trowel.
2.
Paint or tar stains
may need to be removed with a cleaner
such as paint thinner, turpentine, or isopropyl alcohol
(rubbing alcohol). Never allow the cleaner to soak
against the acrylic surface for long periods of time.
Always rinse the surface immediately
following the use of
cleaners.
Note:
Follow the manufacturers instructions for safe use
of cleaning products. If the surface becomes scratched
or dulled, it may be restored by using a quality plastic
polish, like Novus Plastic Polish No. 2 (available from
the Jason Dealer).
It is always preferable to protect the
acrylic surface during installation to minimize cleanup and
prevent surface damage.
WATER TESTING
Before finishing the installation, it is recommended that the
bath be water tested and the plumbing tested for leaks.
1.
Before water testing the bath,
make sure that all plumbing
connections are tight. DO NOT OVERTIGHTEN.
2.
Fill and operate the bath.
Close the drain and fill the bath with
water to at least 10 inches [25 cm] below the bath deck. The
inlet temperature should not exceed 104°F (40°C) as this
could damage the acrylic surface.
3.
Inspect the plumbing for leaks
.
