Jason International, Inc. •
501.771.4477
Page 9 of 16
Customer Service : 800.255.5766
Copyright © 2014 Jason International.
Jason Sani-Design
TM
Cleaning System
The Jason Home Spa bath is equipped with the Jason
Sani-Design
TM
cleaning system. It is located on the top
deck of the bath. The Jason Sani-Design
TM
system makes
easy work of cleaning all of the plumbing and air channels.
The Jason Bath System Cleaner is a specially formulated
solution to aid cleaning of the bath well, all plumbing and air
channels, and is designed to be used in the Sani-Design
TM
System. It cleans the places you could never reach and is a
powerful yet safe and gentle cleaner for you and your bath.
Jets
Strategically placed whirlpool jets are provided for complete
enjoyment of your bath. The jets are specially designed
for maximum whirlpool action with either directional or
rotational capabilities. By changing the direction of the jets,
you can concentrate the massaging jet stream to your area of
preference. You can also individually adjust the flow of each jet.
Pumps
Pumps provided on Jason Air-Whirlpool baths are factory
tested when assembled and retested after installation on
the Air-Whirlpool bath. These pumps are of efficient design
incorporating high quality long life seals which provide superior
service. However, should the pump need service, suction and
discharge unions are provided for easy pump removal.
Blower
The blower generates warm air and pushes it through the air
jets. Blowers provided on Jason AirMasseur baths are factory
tested when assembled and again retested after installation
on the bath.
FIllIng anD DraInIng
Close the drain and fill the bath with water at least two (2)
inches (50mm) above the jets. The inlet temperature should
not exceed 40°C (104°F). When bath is in use, turn the unit Off
before draining the water. The bath unit and its plumbing are
designed to drain after each use.
NOTe:
If the unit fails to operate, check the breaker panel to
insure that the circuit breaker is on. Check the GFCI by testing
and resetting it. Also check the water level in the bath; it must
be above the jets for the pump to operate. If the unit still fails
to operate, refer to the Trouble Shooting Guide section of this
manual. If the unit still fails to operate and is out of warranty,
contact an authorized service technician for repair. If the unit is
within the warranty period, contact JASON Technical Services
at 800-255-5766.
DO NOT aTTeMPT TO ReSOLVe THe
PROBLeM.
opeRating instRUCtions, featURes, and ContRols (cont.)
