Jason International, Inc. •
501.771.4477
Page 6 of 9
Customer Service : 800.255.5766
OPERATING INSTRUCTIONS, FEATURES, AND CONTROLS
INTRODUCTION
This manual contains all of the information needed for the
proper operation of this Integrity
®
Whirlpool bath. The Whirlpool
bath has been designed to provide years of relaxing trouble-
free service, provided the unit is maintained and operated in
accordance with these instructions.
Thoroughly clean and disinfect the unit as described in
the
CLEANING
section of the
USER MAINTENANCE
INSTRUCTIONS
section of this owner’s manual before its
first use and periodically thereafter.
CAUTION:
Keep hair, towels, and clothing away from the
suction fitting whenever the Whirlpool equipment is On.
Never operate the equipment with the suction cover off,
doing so voids the manufacturer’s warranty--it is a safety
cover designed to eliminate the potential of hair and body
entrapment.
All Jason Integrity
®
Whirlpool baths are pre-plumbed at
the factory with standard equipment. Standard equipment
includes five (5) or more directional hydrotherapy jets, and
an air actuated On/Off switch.
WARNING: Before operating refer to the instructions at
the end of this owner’s manual pertaining to the risk of
fire, electric shock, or injury to persons.
FILLING AND DRAINING
Close the drain and fill the bath with water at least two (2) inches
(50mm) above the jets. The inlet temperature should not exceed
40°C (104°F) as this could damage the acrylic surface.
CAUTION: NEVER RUN THE WHIRLPOOL PUMP
WITHOUT ENOUGH WATER IN THE BATH TO COVER
THE JETS.
Before starting the pump, direct the jet nozzles downward
to prevent the possibility of water splashing from the bath.
When bath is in use, turn the unit Off before draining the
water. The bath unit and its plumbing are designed to drain
after each use whether used as a hydrotherapy bath, soaking
bath, or just taking a shower.
AIR ON/OFF BUTTON
The Air On/Off button provides a safe
and convenient method for controlling
the Whirlpool bath. The Air On/Off
button is factory mounted onto the bath
prior to shipment.
See Figure 3
for the
location of the Air On/Off button (air
actuator) on the Whirlpool bath. Fill the
bath to at least two (2) inches above
the highest jet and press the Air On/
Off button to start the whirlpool pump.
Press the Air On/Off button again to
stop the whirlpool pump.
NOTE:
If the unit fails to operate, check the breaker panel
to insure that the circuit breaker is On. Check the ground
fault circuit interrupter (GFCI) by testing and resetting it. If
the unit still fails to operate contact an authorized service
technician for repair.
DO NOT ATTEMPT TO RESOLVE
THE PROBLEM.
JETS
Five or more strategically placed whirlpool jets are provided
for complete enjoyment of the bath. The jets are specially
designed for maximum whirlpool action with direction and flow
control. Changing the direction of the jets will concentrate the
massaging jet stream to the area of preference and turning
the flange of the jet will adjust the amount of flow.
PUMP
The pump provided on Integrity
®
Whirlpool baths is factory
tested when assembled onto the bath. The pump is designed to
incorporate high quality, long-life seals which provide superior
service. However, should the pump need service, use the
suction and discharge unions provided for easy removal.
