© 2018 Jason
®
Hydrotherapy • tech@jasonhydrotherapy.com
Page 12 of 16
Customer Service : 800.255.5766
INSTALLATION INSTRUCTIONS (cont.)
EQUIPMENT CONNECTIONS
All power cords must be connected into the proper 20 amp 120VAC GFCI dedicated circuit for the system. All controls
should be located to permit access for inspection and servicing. Depending on the options ordered on the bath, more than
one outlet may be required.
MICROSILK® [MS] SYSTEM
This MicroSilk bath is provided with an Air On/Off switch and control box. The control box and tubing is temporarily
secured to the bath’s plumbing for shipping. The tubing should be fi rmly attached to the bath’s air switch actuator and the
air switch control box. A small bead of silicone may be added to the air tubing connections to help prevent the tubing from
disengaging.
The air switch tubing must also be installed to allow for a “drop loop” (see Figure below). This will prevent any moisture
from entering the air switch control box from the tubing.
The air switch control box is built to plug into a dedicated GFCI electrical circuit. The MicroSilk unit must be plugged into
the air switch control box, which must be plugged into its dedicated GFCI electrical service prior to turning it on.
HGDL Sspugduge Tgswldg
Vp Fgeldbuge
120[ / 60I
2
20B
Nbmg Ognb
Mlog Dpoogdulpo
Blstxludi
Dpouspm
NT Blstxludi Dpouspm
]BTV-201-01-01-04a
NT
Svnr
P
2
pog
Gps prulpobm P
2
pog, rmvh rvnr
loup p
2
pog evbm rmvh boe uig
evbm rmvh loup uig dpouspm cpyA
Vp Svnr
Vp Dusm Cpy
Remove packing board
