Jason International, Inc. •
501.771.4477
Page 25 of 25
Customer Service : 800.255.5766
Copyright © 2018 Jason International, Inc.
AIRMASSEUR
®
[AM, MA or AW] BLOWER SYSTEM
SYMPTOMS
POSSIBLE CAUSES
RECOMMENDED ACTION
Air bath does not function properly
while in Wave or Pulse mode.
a. Blower speed setting is set too low a. Change to a mid-range air speed
setting before switching over to
Wave or Pulse modes.
Blower turns on when not in use.
a. Purge cycle has started.
a. No action is needed. This is a
normal feature to help keep the air
channel dry and sanitary.
TROUBLE SHOOTING GUIDE
WARRANTY REGISTRATION: Register your product’s warranty online at www.jasoninternational.com.
JASON INTERNATIONAL INC. LIMITED WARRANTY
Jason International, Inc. (Jason), warrants its baths to be free from defects in workmanship and materials as provided in
the enclosed Warranty Statement and Warranty validation card.
The pre-addressed warranty registration card MUST be filled out by the purchaser within thirty (30) days from purchase
and mailed to Jason International, Inc., in order for the limited warranty to become effective.
SAVE THESE INSTRUCTIONS
JASON INTERNATIONAL, INC.
8328 MacArthur Drive • North Little Rock • Arkansas • 72118-2029
www.jasoninternational.com
WHIRLPPOOL [WP, MW or AW] BLOWER SYSTEM
SYMPTOMS
POSSIBLE CAUSES
RECOMMENDED ACTION
Pump operates, but no air is injected
into the water.
a. Air intake clogged.
a. Suction or discharge blocked
Pump operates, but water is not being
pumped.
a. Suction or discharge blocked.
b. Suction air leak. (System usually
surges)
a. Check and remove obstruction
b. Make sure union is tight on suction
side of the pump.
Pump leaks.
a. Damaged or defective seal
b. Unions cracked, under-tightened,
over-tightened or O-Ring is
not seated properly (possibly
pinched).
a. Refer to installer/dealer.
b. Refer to installer/dealer.
Whirlpool jet not working.
a. Jason jets can be individually
opened or closed.
a. Ensure the jet is in the open
position.
